The table lists 53,248 at a 1:256 split in the maximum-density configuration. This is a nominal design figure, not a guaranteed active-subscriber capacity.
FAQ’s
Engineering. Technology. Experience.
The GPON uplink uses a single-mode fiber connection with an SC/APC connector.
The approximately 1.4 Tbps capacity requires the documented uplink extension configuration, which is listed with 48 Combo PON ports.
Four 10GE and six GE interfaces are specified, with GE provided by four SFP and two SFP/RJ45 Combo ports.
A power adapter, external battery-backup/UPS connection and PoE input are described.
The datasheet lists one FXS interface and SIP-compatible voice functionality.
Yes. Conventional OLT and disaggregated pOLT operation are described as configuration options.
Yes. Two central blades can be installed, with the corresponding 192-port maximum shown in the specifications.
The datasheet lists OMCI, CLI and Telnet management capabilities.
Yes. The manufacturer lists a dual-central-switch configuration, with its corresponding capacity and port-count differences.
Not by itself. It provides the GPON ONT function to a suitable host device; routing or Wi-Fi functions depend on that host.
Yes. Two FXS ports and SIP-compatible VoIP functions are listed.
Yes. IEEE 802.1q VLAN and IEEE 802.1p QoS capabilities are listed.
Yes. Installation in a standard 19-inch cabinet is specified.
The datasheet describes a three-level hierarchy applying traffic policies at OLT-port, ONT and service levels.
The datasheet states an operating range from –30°C to +60°C.
No. They are derived from listed port counts and nominal splitter ratios and depend on optical budget and network design.
Not necessarily. The manufacturer states that some capabilities depend on hardware configuration or software release.
The manufacturer specifies OMCI management and a RESTCONF API for OSS/BSS integration.
The internal table contains conflicting port and PSE-channel data. Confirm the total simultaneous PoE budget and port-level power against the current approved specification before deployment.
The document lists standard OMCI remote management and Dying Gasp alerts for loss of power or module removal.
No IP ingress-protection rating is listed in the provided document. Outdoor enclosure suitability should be confirmed for each installation.
The datasheet specifies an operating temperature range of –40°C to +65°C, subject to installation and environmental requirements.
No. The supplied datasheet explicitly calls the 802.3bt capability “pre-standard”.
The technical table states GPON split ratio up to 1:128. Actual network design depends on the optical distribution budget.
The source contains conflicting cumulative wireless rate figures. A verified speed claim should be published only after manufacturer confirmation.
Unlike the smaller PoE models, the GR240P datasheet specifies an SC/UPC GPON interface.
Yes. The source states that every module receives 100% IL and RL testing.
Yes. The listed One-Click™ cleaner variants in the supplied datasheet are stated as compliant with EU Directive 2011/65/EU and (EU) 2015/863 (RoHS2).
Yes. The datasheet states that LC fibers and ports are individually IL/RL tested and numbered, the LC adapters include shutters, and connectors include dust caps.