CONFIGURATION 01
Patch & Splice
For projects that terminate incoming fibers through splice trays and provide patch connections at the distribution panel.
Field-splicing workflow
Fiber ODF 3U Type HD
Fiber ODF 3U Type HD
A front-access fiber optic distribution frame with a sliding tray for structured patching and splicing. Configure the 3U Type HD for up to 144 fiber terminations, with the panel workflow selected to match your installation.
The installation challenge
A fiber panel should be accessible after the rack is populated.
When termination points and splice trays are difficult to reach, routine changes and inspection can become unnecessarily disruptive. The Type HD is arranged so assemblies and splices can be reached from the front panel.
Engineered around front access
The pull-out design supports assembly and operating access without treating the rear of the rack as the primary service area. Side and rear cable entry provide defined routing paths into the frame.
Terminations and splices reached through the front panel
Choose the panel workflow
Three ways to configure the same distribution role.
Specify the Type HD around how optical fiber will be installed and maintained, rather than adapting the workflow to a fixed panel.
CONFIGURATION 02
Patch Only
For installations that need accessible optical cross-connection and patching without a splice workflow in the same panel.
Patching workflow
CONFIGURATION 03
Pre-Terminated
For deployments using a selected cable assembly prepared in advance; indoor HFFR and outdoor cable options are listed in the order matrix.
Pre-terminated workflow
Mechanical & fiber design
Designed for the work inside the ODF.
01
Sliding tray
Access to assemblies from the front during installation and servicing.
02
Bend-aware fiber guidance
Internal routing intended to maintain a large fiber bend radius.
03
Defined cable entries
Large entry openings from the side and rear for incoming fiber cables.
04
Splice & panel components
Splice trays specified for 24 pigtails each; a protective PVC panel is listed.
Technical information
Fiber ODF 3U Type HD specifications.
The parameters below are transcribed from Fibernet’s January 2018 Type HD datasheet. Selectable variations are shown separately from the standard 3U capacity.
| Product | Fiber ODF – Type HD |
|---|---|
| 3U termination capacity | Up to 144 fibers (SC / ST / FC) |
| Frame heights | 3U; optional 1U and 2U configurations |
| Rack width options | 19″, 21″, 23″ |
| Frame depth | 340 mm |
| Front-panel orientation | Left-oriented (per datasheet) |
| Finish | Black, RAL 9005 |
| Standards reference | GR-449-CORE (conformance stated in datasheet) |
Capacity note: The published 144-fiber figure applies to the 3U configuration. Capacity and accessory selection for optional 1U/2U versions should be confirmed with Fibernet.
Available order selections
The ordering matrix identifies the following technical choices; their availability and combinations should be validated for the project.
Front-panel adapter
SCSTFCOther on request
Fiber type
50/12562.5/125Single-ModeG.657.A2 BIG.655 BIOM3 BIOM4 BI
Additional options
96 / 144 positions shownUPC / APCIndoor HFFR cableOutdoor cableSpecified cable length
Fibernet manufacturing
A defined panel configuration, ready for technical review.
For an accurate quotation, provide the panel type, fiber and adapter selection, rack interface and any pre-terminated cable requirements. Fibernet operates according to ISO 9001:2015, ISO 13485:2016, and AS9100D quality management standards.
✓
Plan the panel around your installation
Specify the optical distribution task.
We’ll discuss the right configuration.
Share the rack width, panel type, fiber count, adapters and cable requirements. Our team can review the Type HD configuration for your installation.